Non-towered · Class G at the surface
Bedford County (KHMZ) radio calls
Bedford, PAICAO KHMZ · FAA HMZ
Bedford County is a non-towered airport in Bedford, PA. Nobody clears you to do anything: you self-announce on the CTAF, 122.7, as Bedford County Traffic, with the airport name at the start and end of each call. The approach control for the area is Johnstown Approach on 121.2, which is who you call for VFR flight following.
No Class B, C, D or E surface area is designated for this airport in the FAA data, so the airspace at the surface is Class G.
Frequencies
| CTAFBedford County Traffic | 122.7 |
|---|---|
| Approach / DepartureJohnstown Approach | 121.2 |
Airport
- Runways
- 14 · 32
- Right-hand pattern
- Runway 14
- Elevation
- 1,162 ft
- Position
- 40.086, -78.513
Non-towered airport: self-announce on the CTAF
Sample calls at KHMZ
Bedford County has no operating control tower. Every call below goes out on the CTAF, 122.7, to the other aircraft, not to a controller. The runway shown is 14, which has a right-hand pattern; use whichever runway the wind and the traffic dictate on the day.
The aircraft is the AIM’s own example, Cessna Three One Six Zero Foxtrot; the squawk codes, altitudes and headings are illustrative. Frequencies, station names and runway numbers are this airport’s, from the FAA data.
- Tune 122.7. Nobody clears you; you announce and you listen. The airport name goes at the start and the end of every call, and the runway is always a number, never "the active" (AIM 4-1-9 g 8).
- YouBedford County traffic, Cessna Three One Six Zero Foxtrot, taxiing to runway one four, Bedford County.
- YouBedford County traffic, Cessna Six Zero Foxtrot, departing runway one four, departing the pattern to the north, Bedford County.
- Announce until you are about 10 miles out; on the way back, start announcing at 10 miles (AIM 4-1-9 c 1, TBL 4-1-1).
- YouBedford County traffic, Cessna Three One Six Zero Foxtrot, one zero miles south, two thousand five hundred, landing Bedford County, Bedford County.
- YouBedford County UNICOM, Cessna Six Zero Foxtrot, one zero miles south, request wind and runway information, Bedford County.
- A UNICOM operator, if one is on, answers with the wind and the runway in use (AIM 4-1-9 h). If nobody answers, choose the runway from the wind and the pattern traffic you can hear.
- YouBedford County traffic, Cessna Six Zero Foxtrot, entering left downwind runway one four, full stop, Bedford County.
- YouBedford County traffic, Cessna Six Zero Foxtrot, left base runway one four, Bedford County.
- YouBedford County traffic, Cessna Six Zero Foxtrot, final runway one four, full stop, Bedford County.
- YouBedford County traffic, Cessna Six Zero Foxtrot, clear of runway one four, Bedford County.
If things change. Want flight following after departure? Call Johnstown Approach on 121.2 once clear of the pattern: identification, type, position, altitude, destination, "request VFR flight following" (AIM 4-1-18 a 3). Do not use "any traffic in the area, please advise"; the AIM says it is not to be used under any condition (AIM 4-1-9 g 1).
Phraseology from AIM 4-1-9 c 1, g 1, g 8, h; TBL 4-1-1; 4-3-3. What TowerTalk grades against →
The calls you will make here
Nearby in Pennsylvania
- KAOOAltoona/Blair Countynon-towered
- P17Greater Breezewood Regionalnon-towered
- KJSTJohn Murtha Johnstown/Cambria Countytowered
- 2G9Somerset Countynon-towered
- 6G6Cove Valleynon-towered
- 9G8Ebensburgnon-towered
Frequencies, runways and airspace from the FAA National Airspace System Resources (NASR) 28-day subscription, cycle effective Sep 3, 2026. Training use only. Always verify against a current Chart Supplement and sectional chart before flight; frequencies change. TowerTalk is not affiliated with the FAA. Report a discrepancy.
This page is in release tier 2 and is not yet submitted to search engines.