Non-towered · Class G at the surface
Hartsville Regional (KHVS) radio calls
Hartsville, SCICAO KHVS · FAA HVS
Hartsville Regional is a non-towered airport in Hartsville, SC. Nobody clears you to do anything: you self-announce on the CTAF, 122.8, as Hartsville Regional Traffic, with the airport name at the start and end of each call. The approach control for the area is Shaw Approach on 125.4, which is who you call for VFR flight following.
No Class B, C, D or E surface area is designated for this airport in the FAA data, so the airspace at the surface is Class G.
Frequencies
| CTAFHartsville Regional Traffic | 122.8 |
|---|---|
| Approach / DepartureShaw Approach | 125.4 |
Airport
- Runways
- 03 · 21
- Right-hand pattern
- Runway 03
- Elevation
- 364 ft
- Position
- 34.403, -80.119
Non-towered airport: self-announce on the CTAF
Sample calls at KHVS
Hartsville Regional has no operating control tower. Every call below goes out on the CTAF, 122.8, to the other aircraft, not to a controller. The runway shown is 03, which has a right-hand pattern; use whichever runway the wind and the traffic dictate on the day.
The aircraft is the AIM’s own example, Cessna Three One Six Zero Foxtrot; the squawk codes, altitudes and headings are illustrative. Frequencies, station names and runway numbers are this airport’s, from the FAA data.
- Tune 122.8. Nobody clears you; you announce and you listen. The airport name goes at the start and the end of every call, and the runway is always a number, never "the active" (AIM 4-1-9 g 8).
- YouHartsville Regional traffic, Cessna Three One Six Zero Foxtrot, taxiing to runway zero three, Hartsville Regional.
- YouHartsville Regional traffic, Cessna Six Zero Foxtrot, departing runway zero three, departing the pattern to the north, Hartsville Regional.
- Announce until you are about 10 miles out; on the way back, start announcing at 10 miles (AIM 4-1-9 c 1, TBL 4-1-1).
- YouHartsville Regional traffic, Cessna Three One Six Zero Foxtrot, one zero miles south, two thousand five hundred, landing Hartsville Regional, Hartsville Regional.
- YouHartsville Regional UNICOM, Cessna Six Zero Foxtrot, one zero miles south, request wind and runway information, Hartsville Regional.
- A UNICOM operator, if one is on, answers with the wind and the runway in use (AIM 4-1-9 h). If nobody answers, choose the runway from the wind and the pattern traffic you can hear.
- YouHartsville Regional traffic, Cessna Six Zero Foxtrot, entering left downwind runway zero three, full stop, Hartsville Regional.
- YouHartsville Regional traffic, Cessna Six Zero Foxtrot, left base runway zero three, Hartsville Regional.
- YouHartsville Regional traffic, Cessna Six Zero Foxtrot, final runway zero three, full stop, Hartsville Regional.
- YouHartsville Regional traffic, Cessna Six Zero Foxtrot, clear of runway zero three, Hartsville Regional.
If things change. Want flight following after departure? Call Shaw Approach on 125.4 once clear of the pattern: identification, type, position, altitude, destination, "request VFR flight following" (AIM 4-1-18 a 3). Do not use "any traffic in the area, please advise"; the AIM says it is not to be used under any condition (AIM 4-1-9 g 1).
Phraseology from AIM 4-1-9 c 1, g 1, g 8, h; TBL 4-1-1; 4-3-3. What TowerTalk grades against →
The calls you will make here
Nearby in South Carolina
- 2Q0Flying wnon-towered
- 52JLee County/Butters Fieldnon-towered
- KUDGDarlington Countynon-towered
- 6J7Branhamsnon-towered
- 58JHuggins Memlnon-towered
- KCQWCheraw Municipal/Lynch Bellinger Fieldnon-towered
Frequencies, runways and airspace from the FAA National Airspace System Resources (NASR) 28-day subscription, cycle effective Sep 3, 2026. Training use only. Always verify against a current Chart Supplement and sectional chart before flight; frequencies change. TowerTalk is not affiliated with the FAA. Report a discrepancy.
This page is in release tier 2 and is not yet submitted to search engines.