Non-towered · Class G at the surface

Hardin County (I95) radio calls

Kenton, OHFAA identifier I95; no ICAO code assigned

Hardin County is a non-towered airport in Kenton, OH. Nobody clears you to do anything: you self-announce on the CTAF, 122.8, as Hardin County Traffic, with the airport name at the start and end of each call. The approach control for the area is Columbus Approach on 134.45, which is who you call for VFR flight following.

No Class B, C, D or E surface area is designated for this airport in the FAA data, so the airspace at the surface is Class G.

Frequencies

CTAFHardin County Traffic122.8
Approach / DepartureColumbus Approach134.45

Airport

Runways
04 · 22
Right-hand pattern
Runway 04
Elevation
1,029 ft
Position
40.610, -83.644

Non-towered airport: self-announce on the CTAF

Sample calls at I95

Hardin County has no operating control tower. Every call below goes out on the CTAF, 122.8, to the other aircraft, not to a controller. The runway shown is 04, which has a right-hand pattern; use whichever runway the wind and the traffic dictate on the day.

The aircraft is the AIM’s own example, Cessna Three One Six Zero Foxtrot; the squawk codes, altitudes and headings are illustrative. Frequencies, station names and runway numbers are this airport’s, from the FAA data.

  1. Tune 122.8. Nobody clears you; you announce and you listen. The airport name goes at the start and the end of every call, and the runway is always a number, never "the active" (AIM 4-1-9 g 8).
  2. YouHardin County traffic, Cessna Three One Six Zero Foxtrot, taxiing to runway zero four, Hardin County.
  3. YouHardin County traffic, Cessna Six Zero Foxtrot, departing runway zero four, departing the pattern to the north, Hardin County.
  4. Announce until you are about 10 miles out; on the way back, start announcing at 10 miles (AIM 4-1-9 c 1, TBL 4-1-1).
  5. YouHardin County traffic, Cessna Three One Six Zero Foxtrot, one zero miles south, two thousand five hundred, landing Hardin County, Hardin County.
  6. YouHardin County UNICOM, Cessna Six Zero Foxtrot, one zero miles south, request wind and runway information, Hardin County.
  7. A UNICOM operator, if one is on, answers with the wind and the runway in use (AIM 4-1-9 h). If nobody answers, choose the runway from the wind and the pattern traffic you can hear.
  8. YouHardin County traffic, Cessna Six Zero Foxtrot, entering left downwind runway zero four, full stop, Hardin County.
  9. YouHardin County traffic, Cessna Six Zero Foxtrot, left base runway zero four, Hardin County.
  10. YouHardin County traffic, Cessna Six Zero Foxtrot, final runway zero four, full stop, Hardin County.
  11. YouHardin County traffic, Cessna Six Zero Foxtrot, clear of runway zero four, Hardin County.

If things change. Want flight following after departure? Call Columbus Approach on 134.45 once clear of the pattern: identification, type, position, altitude, destination, "request VFR flight following" (AIM 4-1-18 a 3). Do not use "any traffic in the area, please advise"; the AIM says it is not to be used under any condition (AIM 4-1-9 g 1).

Phraseology from AIM 4-1-9 c 1, g 1, g 8, h; TBL 4-1-1; 4-3-3. What TowerTalk grades against →

The calls you will make here

Nearby in Ohio

Frequencies, runways and airspace from the FAA National Airspace System Resources (NASR) 28-day subscription, cycle effective Oct 29, 2026. Training use only. Always verify against a current Chart Supplement and sectional chart before flight; frequencies change. TowerTalk is not affiliated with the FAA. Report a discrepancy.