Non-towered · Class G at the surface
Stevensville (32S) radio calls
Stevensville, MTFAA identifier 32S; no ICAO code assigned
Stevensville is a non-towered airport in Stevensville, MT. Nobody clears you to do anything: you self-announce on the CTAF, 122.8, as Stevensville Traffic, with the airport name at the start and end of each call. The approach control for the area is Spokane Approach on 124.9, which is who you call for VFR flight following.
No Class B, C, D or E surface area is designated for this airport in the FAA data, so the airspace at the surface is Class G.
Frequencies
| CTAFStevensville Traffic | 122.8 |
|---|---|
| Approach / DepartureSpokane Approach | 124.9 |
Airport
- Runways
- 12 · 30
- Elevation
- 3,614 ft
- Pattern altitude
- 800 ft MSL (published TPA)
- Position
- 46.525, -114.053
Non-towered airport: self-announce on the CTAF
Sample calls at 32S
Stevensville has no operating control tower. Every call below goes out on the CTAF, 122.8, to the other aircraft, not to a controller. The runway shown is 12; use whichever runway the wind and the traffic dictate on the day.
The aircraft is the AIM’s own example, Cessna Three One Six Zero Foxtrot; the squawk codes, altitudes and headings are illustrative. Frequencies, station names and runway numbers are this airport’s, from the FAA data.
- Tune 122.8. Nobody clears you; you announce and you listen. The airport name goes at the start and the end of every call, and the runway is always a number, never "the active" (AIM 4-1-9 g 8).
- YouStevensville traffic, Cessna Three One Six Zero Foxtrot, taxiing to runway one two, Stevensville.
- YouStevensville traffic, Cessna Six Zero Foxtrot, departing runway one two, departing the pattern to the north, Stevensville.
- Announce until you are about 10 miles out; on the way back, start announcing at 10 miles (AIM 4-1-9 c 1, TBL 4-1-1).
- YouStevensville traffic, Cessna Three One Six Zero Foxtrot, one zero miles south, two thousand five hundred, landing Stevensville, Stevensville.
- YouStevensville UNICOM, Cessna Six Zero Foxtrot, one zero miles south, request wind and runway information, Stevensville.
- A UNICOM operator, if one is on, answers with the wind and the runway in use (AIM 4-1-9 h). If nobody answers, choose the runway from the wind and the pattern traffic you can hear.
- YouStevensville traffic, Cessna Six Zero Foxtrot, entering left downwind runway one two, full stop, Stevensville.
- YouStevensville traffic, Cessna Six Zero Foxtrot, left base runway one two, Stevensville.
- YouStevensville traffic, Cessna Six Zero Foxtrot, final runway one two, full stop, Stevensville.
- YouStevensville traffic, Cessna Six Zero Foxtrot, clear of runway one two, Stevensville.
If things change. Want flight following after departure? Call Spokane Approach on 124.9 once clear of the pattern: identification, type, position, altitude, destination, "request VFR flight following" (AIM 4-1-18 a 3). Do not use "any traffic in the area, please advise"; the AIM says it is not to be used under any condition (AIM 4-1-9 g 1).
Phraseology from AIM 4-1-9 c 1, g 1, g 8, h; TBL 4-1-1; 4-3-3. What TowerTalk grades against →
The calls you will make here
Nearby in Montana
- KHRFRavalli Countynon-towered
- RC0Rock Creeknon-towered
- KMSOMissoula Montanatowered
- U05Riddick Fieldnon-towered
- M26Drummondnon-towered
- 4U7West Fork Lodgenon-towered
Frequencies, runways and airspace from the FAA National Airspace System Resources (NASR) 28-day subscription, cycle effective Sep 3, 2026. Training use only. Always verify against a current Chart Supplement and sectional chart before flight; frequencies change. TowerTalk is not affiliated with the FAA. Report a discrepancy.
This page is in release tier 2 and is not yet submitted to search engines.