Non-towered · Class G at the surface

Lansdowne (04G) radio calls

Youngstown, OHFAA identifier 04G; no ICAO code assigned

Lansdowne is a non-towered airport in Youngstown, OH. Nobody clears you to do anything: you self-announce on the CTAF, 122.8, as Lansdowne Traffic, with the airport name at the start and end of each call. The approach control for the area is Youngstown Approach on 133.95, which is who you call for VFR flight following.

No Class B, C, D or E surface area is designated for this airport in the FAA data, so the airspace at the surface is Class G.

Frequencies

CTAFLansdowne Traffic122.8
Approach / DepartureYoungstown Approach133.95

Airport

Runways
02 · 20
Elevation
1,044 ft
Position
41.130, -80.620

Non-towered airport: self-announce on the CTAF

Sample calls at 04G

Lansdowne has no operating control tower. Every call below goes out on the CTAF, 122.8, to the other aircraft, not to a controller. The runway shown is 02; use whichever runway the wind and the traffic dictate on the day.

The aircraft is the AIM’s own example, Cessna Three One Six Zero Foxtrot; the squawk codes, altitudes and headings are illustrative. Frequencies, station names and runway numbers are this airport’s, from the FAA data.

  1. Tune 122.8. Nobody clears you; you announce and you listen. The airport name goes at the start and the end of every call, and the runway is always a number, never "the active" (AIM 4-1-9 g 8).
  2. YouLansdowne traffic, Cessna Three One Six Zero Foxtrot, taxiing to runway zero two, Lansdowne.
  3. YouLansdowne traffic, Cessna Six Zero Foxtrot, departing runway zero two, departing the pattern to the north, Lansdowne.
  4. Announce until you are about 10 miles out; on the way back, start announcing at 10 miles (AIM 4-1-9 c 1, TBL 4-1-1).
  5. YouLansdowne traffic, Cessna Three One Six Zero Foxtrot, one zero miles south, two thousand five hundred, landing Lansdowne, Lansdowne.
  6. YouLansdowne UNICOM, Cessna Six Zero Foxtrot, one zero miles south, request wind and runway information, Lansdowne.
  7. A UNICOM operator, if one is on, answers with the wind and the runway in use (AIM 4-1-9 h). If nobody answers, choose the runway from the wind and the pattern traffic you can hear.
  8. YouLansdowne traffic, Cessna Six Zero Foxtrot, entering left downwind runway zero two, full stop, Lansdowne.
  9. YouLansdowne traffic, Cessna Six Zero Foxtrot, left base runway zero two, Lansdowne.
  10. YouLansdowne traffic, Cessna Six Zero Foxtrot, final runway zero two, full stop, Lansdowne.
  11. YouLansdowne traffic, Cessna Six Zero Foxtrot, clear of runway zero two, Lansdowne.

If things change. Want flight following after departure? Call Youngstown Approach on 133.95 once clear of the pattern: identification, type, position, altitude, destination, "request VFR flight following" (AIM 4-1-18 a 3). Do not use "any traffic in the area, please advise"; the AIM says it is not to be used under any condition (AIM 4-1-9 g 1).

Phraseology from AIM 4-1-9 c 1, g 1, g 8, h; TBL 4-1-1; 4-3-3. What TowerTalk grades against →

The calls you will make here

Nearby in Ohio

Frequencies, runways and airspace from the FAA National Airspace System Resources (NASR) 28-day subscription, cycle effective Oct 29, 2026. Training use only. Always verify against a current Chart Supplement and sectional chart before flight; frequencies change. TowerTalk is not affiliated with the FAA. Report a discrepancy.